PCD STOCK INSERTS
| COMPAX* DIAMOND | ||||||||||||||||||||||||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||||||||||||||||||||||
| *COMPAX DIAMOND is a registered Trademark of General Electric Company, USA. |
- "S" - Indicates a stocked item.
- All stock PCD inserts are made with COMPAX DIAMOND. Other grades, PCD edge lengths, insert styles and sized will be quoted on request.
- NOTE: Minimum PCD edge for all stock inserts is .125" (†) Except for TPG-221 and TPG-222, which have minimum PCD edges of .095" and .085" respectively.
ACT can rebuild or relap your used PCD or CBN inserts.
Please call for pricing.
WARNING: PCD DEPTH OF CUT SHOULD NOT EXCEED 60% OF TOTAL CUTTING EDGE AVAILABLE.
When Using Superabrasive Cutting Tools:
- Use rigid machining system and minimize insert overhang.
- Clean seat of tool holder prior to use and changing of insert.
- Tool holder and seat must be in good condition, free of wear.
- Machining system must be capable of running at the recommended speeds.
- Do not exceed depth of cut as recommended in the applications guidelines.
- Do not stop machine in cut as insert breakage may occur.
- Interrupted cut may require an additional hone. If applicable, please indicate when ordering.
3620 Progress St. NE
Canton OH 44705
PH: (330) 455-2009
FX: (330) 453-8498
Photo provided courtesy of GE Superabrasives